Wires

In order to easily connect buttons to your PCB Brook, we propose a beam that connects directly to the JST connector of your PCB Brook.

JLF-H type cable with five-point joystick connector and five PCB-independent connectors.
Hitbox 5-pin conversion wiring allows you to replace a joystick with a 5-point connector with buttons.

JLF-H cable connector with five points for Sanwa joystick JLF-TP.
Note: Colors may vary depending on the Supplier profile.

JLF-H Cable with five-point side joystick and five independent connectors for PCB Connect.
Note: Colors may vary depending on the provider.

This cable can be used on all SANWA joysticks sold on SmallCab or on Seimitsu LS-(XX)-01 instead of the traditional 5-pin cable.
The other end of the cable (JST-XH format) can then be connected to the controller board of many Arcade stick models.

The JST-XH cable can be used on SANWA joysticks in the JLF-TP range or on Seimitsu LS- (XX) -01 instead of the traditional 5-pin cable.
The other end of the cable can then be connected to the controller board in many Arcade stick models.