Lot cable to connect two joysticks and 17 buttons on the GPIO port RaspBerry Pi 2, Pi 3 ou Pi 4
Please note, only the RecalBox and Batocera distributions support the management of controls on the GPIO port.
17 wire of 80cm with dupont connector and terminal 2.8.
8 wire 80cm with dupont connector and terminal 4.8.
2 wire 80cm with dupont connector, a common ground chain and 2.8mm terminals for buttons and 4.8mm terminal for joysticks.
Supplied with an installation manual.
GPIO schema used by the RecalBox distribution:
Plus d'information sur :
Wiki RecalBox : Connexion GPIO
GPIO schema used by the Batocera distribution
Wiki Batocera : GPIO pads