Ben Factory

Fuse holder cards are the essential complements to your solenoids.
With its diode, your solenoid will protect against voltage returns.
And, if the coil 'jams', the fuse will trip before melting your electrical installation.

This molex to terminal block converter will allow you to recover the 5V and 12V voltages from any molex connector of an ATX power supply.
The various voltages will be directly recoverable on the various terminal blocks provided for this purpose.

The Shield KL25 - Plunger pack is a simplified connection solution for your Pincab project.
This scalable pack will accompany you throughout the development of your Pincab project.
It will allow you to connect the first basic elements of your Pincab (buttons and ball lance).

This PCB has 5 buttons and a six point terminal block.
It offers five service buttons (Door, volume management (+ -), Exit and Enter).

To facilitate the installation of your DMDs on your Pincab, we offer you a DMD P2.5 pack ready to be installed.
This pack includes two DMD P2.5 panels installed on their frame, an STM32 PCB with its updated firmware and the Pin2DMD software installed (License not included and to be paid for).
This set will save you time when installing the DMD on your pincab.

To facilitate the installation of your LED Bar, we offer you an all-in-one pack.
This pack includes five RGB LEDs attached to a PCB to install on your Pincab.
The Ultimate power light board was designed to be connected to a Freescale