Controller cards

20cm Dupont male female cables.
With this set of 40 cables, you will have the necessary to connect a Freescale card to Mosfets to control Toys.

USB Power is a card that allows you to:
- Provide more amperage to your USB devices.
- Turn off the power of your USB devices when the PC is off.

Fuse 5x20mm and 0.5 Amp

Fuse 5x20mm and 1 Amp

Fuse 5x20mm and 2 Amp

Fuse 5x20mm and 3 Amp

Fuse 5x20mm and 4 Amp

Fuse 5x20mm and 5 Amp

The Shield KL25 pack is a simplified connection solution for your Pincab project.
This scalable pack will accompany you throughout the development of your Pincab project.
It will allow you to connect the first basic elements of your Pincab (buttons and ball launcher).

SmallCab presents its filter machine! This card will allow you to reduce the parasites that could be created by your toys. It is placed closest to the toy for maximum efficiency.

The FRDM KL25Z Freescale Card is an essential element for any Pincab project.
Indeed, this card allows you to manage your buttons (Start, insert coin, launch ball, etc.). It also allows you to manage the Toys of your Pincab like the classic plunger and others. Its integrated accelerometer will allow you to manage the famous 'Tilt'.

This PCB has 5 buttons and a six point terminal block.
It offers five service buttons (Door, volume management (+ -), Exit and Enter).

The STM32 NUCLEO 144 - F429ZI PCB is the development board used by the V4 shields of the Pin2DMD team.
This card will ensure long-term support for the evolutions of the Pin2DMD software.

The Freescale FRDM KL25Z Card is an indispensable element for any Pincab project.
We offer it here with its pin male connection and Firmware 'Pinscape' installed.
The PCB being installed / configured by our technical service there can be no failure at startup!

The SC-Plunger pack is a simplified connection solution.
It consists of a linear stereo slide potentiometer, on which a PCB with 3 connectors is soldered.
These three connectors will allow you to connect the potentiometer to the KL25Z via the 80cm Dupont cable provided.
This pack is exclusively designed for the ball lance of your Pincab.

This kit includes a Teensy 3.2 microcontroller and an octoWS2811 PJRC adapter.
This kit is frequently used as 'ledstrips controllers' on the pincab.

The 4 mosfets PCB Toys board is a board for managing up to 8 PWM outputs.
Mosfets are used to power toys such as solenoids, contactors, shaker etc.

The 8 mosfets PCB Toys board is a board for managing up to 8 PWM outputs.
Mosfets are used to power toys such as solenoids, contactors, shaker etc.